PARTS and COMPONENTS
PROBLEM
SOLUTION
Screws won’t drive.
They spin for a second, then lay over
on their side. Little or no penetration.
Make sure the screwdriver motor is NOT in reverse.
Check for correct bit.
Ensure adjusting arm is 1/8” from the screw tip.
Screws won’t drive completely.
They go down about halfway, then
the bit spins out.
Check to be sure you are using the correct bit for the type of screws you are driving.
Check for bit wear. It may be time to install a new bit.
Push harder when driving.
Screws won’t drive completely.
They are almost completely driven
but won’t seat completely.
Check the depth adjustment on the attachment. Reset if necessary.
You may have missed the substrate.
Ensure pressure is being applied during screw installation until clutch on
screwdriver motor disengages.
Screws don’t advance properly
causing tool to jam.
Use only genuine Quik Drive brand collated screws.
Lift tool completely off the work surface after driving each screw.
Ensure adjusting arm is 1/8” from the screw tip.
Technical Support
800-999-5099
Using the correct driving bit is necessary.
Variations in materials and driving technique can cause excessive wear so additional bit packs are available for purchase.
REPLACEMENT PART PRODUCT CODES:
Replacement Bits: BITBLLBHEX14
•
- Ball-lock lobular hex 1/4
"
|
BITBLLBHEX516
- Ball-lock lobular hex 5/16
"
Replacement Mandrel Set: BLMANDRELBGP
•
- Includes mandrel, washer and retaining ring
Replacement Adjusting Arm: PADJARMBGP300G2
•
- Does not include panel guides
TROUBLESHOOTING GUIDE
ATTACHMENT
EXTENSION
SCREWDRIVER MOTOR
BLMANDRELBGP MANDREL
found inside attachment
FASTENER RELEASE BUTTON
PROFILE GUIDE CLAMP SCREW
DEPTH ADJUSTMENT KNOB
HANDLE TO BE USED
WITHOUT EXTENSION
INTERCHANGEABLE
PROFILE GUIDE
SHAFT
factory installed, inside extension
PADJARMBGP300G2
Adjusting Arm
PPROFILEGUIDE32
R-Panel Profile Guide
INTERCHANGEABLE
PROFILE GUIDES
PPROFILEGUIDE11
Flat Profile Guide
