Simpson SCGH5500, Инструкция по использованию и уходу, Страница: 29 / 36

Page 27 REV F - 07/22/2021 Part Number 7115316 / ENGLISH
Storing for More Than Two Months
1. Make sure the engine is completely cool.
2. Turn the fuel valve to the ON position.
3. Remove all the fuel from fuel tank, fuel lines, and carburetor by loosening the drain
screw at the bottom of the carburetor, then drain fuel into an appropriate container.
4. Turn the fuel valve to the OFF position.
5. Change the engine oil.
6. Remove any dirt and debris from the area around the spark plug, then Use a spark plug
socket or wrench to remove the spark plug.
7. Pour .5 ounces (15 ml) of new oil into the engine combustion chamber, then slowly crank
the engine by pulling the recoil two (2) times to distribute oil and lubricate the cylinder.
8. Install the spark plug.
9. For electric start models, remove the battery and place it on a smart charger per the
MAINTENANCE section of this manual.
10. Clean the generator per the MAINTENANCE section of this manual.
11. Store the generator and battery in a clean, dry area that is out of direct sunlight.
1. Place the fuel valve to the OFF position.
2. Turn the engine control switch to the OFF position.
3. To prevent fuel spillage when transporting, keep the generator upright on a level surface.
4. Secure generator with straps or tie downs to prevent tip over and damage from sliding.
NOTE: Do not operate the generator while it is on the transport vehicle.
Leaving the generator in an enclosed space on the transport vehicle where temperatures
can rise may cause fuel to vaporize and possibly explode. Fire and explosions can cause
severe burns and/or death. To avoid leaking or vaporizing fuel, secure the generator in a
well ventilated area on the transport vehicle that is out of direct sunlight and other heat
sources and do not transport the generator on rough roads unless the fuel has been
drained beforehand.
TRANSPORTATION
Transportation