Simpson SCGH5500, Инструкция по использованию и уходу, Страница: 21 / 36

ON
START
RUN
OPEN CLOSED
Page 19 REV F - 07/22/2021 Part Number 7115316 / ENGLISH
2. Pull the starter recoil.
1. Turn the engine control switch to
the ON position.
1. Use key to turn the engine control
switch to the START position then
release key when engine starts.
6. Start the engine.
NOTE: This manual covers generator models that feature both electric and manual start.
Refer to the CONTROL PANELS section of this manual to determine if your model is electric
or manual start, then follow the sequence below that is relevant to your model.
Electric Start Models Manual Start Models
7. After the engine is running, move the choke lever towards the open position.
8. Allow the engine to warm up and the idle to stabilize before connecting any devices or
turning the idle control switch on.
2. The engine control switch stays in
the RUN position during operation.
RAPID RETRACTION
Rapid retraction (also known as kickback) of the engine recoil starter cord will pull your
hand and arm towards the engine faster than you can let go of the handle resulting in
sprains, broken bones, lacerations, and/or traumatic amputations. Kickback is caused
by damage to the engine crankshaft key, compression release failure, and/or improper
starting techniques. To avoid kickback follow the appropriate maintenance schedule,
starting instructions, and have repair work done by an authorized service center.