Stacking Features
The mounting brackets, included with every Mini-Max, can be connect-
ed together. Multiple units can be mounted in a single opening, allow-
ing perfect alignment.
To punch one hole for multiple units, be sure to adjust the standard
panel cutout dimensions as shown here; otherwise the meters will not
fit properly in the hole.
Mounting multiple units is quick and easy. Install the first meter (bottom
unit first if stacking vertically). Position the next mounting bracket snug-
ly against the first one, and slide the second meter into place. Repeat
for remaining units.
2.68" (68 mm)
.071" (1.8 mm)
.88" (22.2 mm)
Standard cutout
Add to standard
when stacking
.
88" (22.2 mm)
2.68" (68mm)
Standard cutout
.16" (4.0mm)
Add to standard when stacking
Horizontal
Vertical
Vertical
Horizontal
Excitation Output
Excitation output is available in the Mini-Max for
powering external transmitters or transducers.
Excitation is available from the EX POS and EX NEG
terminals. This source is isolated from the measure-
ment input as well as the input power circuits. The
voltages available are 12VDC or 24VDC, with a
maximum load current of 25 milliamps. This feature
eliminates the need to mount an external DC power
source for transducers or sensors used in your
application.
Do not exceed an excitation
load current of 25mA!
EX NEG
EX POS
Backlight Option and Decimal Point Selection
Negative image, bright red backlighting is available
in the Mini-Max. This illumination allows the unit to
be read in low light areas. Backlighting power is
supplied by the Mini-Max, so no additional external
power is required.
Decimal point selection is accomplished by con-
necting the appropriate DP terminal to the DP
Common terminal.
DP COMMON
(HOLD)
3 2 1
G
DP 4
DP 2
DP 3
4*
*NOTE: If the Display
Hold option is ordered,
it replaces DP4 on the
Terminal Connector.
DP 1
DP4
DP3
DP1
DP2