22
Build - in
This dishwasher is designed to be fitted either
under a kitchen counter or a worksurface.
It is essential that the recess dimensions
indicated in the illustration are followed.
No further openings for venting of the
dishwasher are required, but only to let the
water fill and drain hose and power supply
cable pass through.
The height of the recess where the dishwasher
is to be installed can vary between 820 and
880 mm from the floor since the dishwasher is
fitted with adjustable feet (max. 60 mm).
Leave a space of 2 mm between the top of the
dishwasher and the underside of the kitchen
counter.
Adjusting the height of the dishwasher
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot by turning the screw in
the middle of the front kick plate to the left
or to the right.
Good levelling is essential for correct closure
and sealing of the door. When the appliance is
correctly levelled, the door will not catch on the
levelling spacers on either side of the cabinet.
If the door does not close properly, loosen or
tighten the adjustable feet until the machine is
perfectly level.
Adjusting the height of the plinth
It is important for the dishwasher to be
absolutely horizontal so that the door seals
properly.
The adjustable feet are to be turned to the left
or right until the dishwasher is horizontal.
If there is a space at the bottom of the
machine, this can be covered by lowering the
plinth.
Fitting the steam protection
Fit the steam protection onto the front part of
the worktop, using the screws provided.
156995010.qxp 4/4/2007 12:56 PM Pagina 22