Simpson 13SIE-170, Инструкция по эксплуатации, Страница: 14 / 42

14- ENG
5. Plug GFCI (C) into power receptacle. Firmly press and release the TEST button
(X), then press and release the RESET button (W). The light on the GFCI should
be illuminated.
W
x
C
12
6. Ensure the gun safety is unlocked and squeeze the trigger until the air has
escaped and a steady flow of low pressure water is coming from the nozzle.
NOTE: The power supply must be 120 V, 60 Hz and a minimum 15 amp
dedicated circuit.
7. Turn switch to ON position (I). Note that the motor will momentarily start then
stop.
8. Squeeze the trigger to start motor and begin pressure washing.
NOTE:
The motor only runs when the gun trigger is depressed and water is
spraying.
13
ON OFF
14
I
SHUTTING DOWN
See Storage section in this manual for proper shutdown and storage procedures.
MAINTENANCE
Risk of burn hazard. When perfrming maintenance, you may be exposed
to hot surfaces, water pressure or moving parts that can cause serious injury
or death.
To ensure efficient operation and longer life of your pressure washer, a routine
maintenance schedule should be prepared and followed. If the pressure washer is
used in unusual conditions, such as high-temperatures or dusty conditions, more
fre quent maintenance checks will be required.
CONNECTIONS
Connections on pressure washer hoses, gun and spray wand should be cleaned
regularly and lubricated with light oil or lithium grease to prevent leakage and
damage to the o-rings.
NOzzLE
The nozzles should be cleaned regularly.
Clogging of the nozzle causes diminished performance and the pump pressure to
be too high and cleaning is immediately required.