Simpro QUIKSTAK QS10MM, Руководство пользователя

Страница: 20 / 52

4. Care and Maintenance
The Quikstak is designed to give many years of service with minimal maintenance. In the
event a fault or malfunction does occur, refer to the Quick Troubleshooting Guide in
§4.1
before contacting your agent for support.
Contact your agent in the first instance if repair or service work is required.
All repair and service work must be carried out by a qualified, authorised technician.
Replacement parts must be supplied by Simpro or an authorized Simpro agent, and must
be of the same design and specification as the original parts.
A detailed Service Manual giving specific testing and repair instructions is available on
request from Simpro.
4.1 Quick Troubleshooting Guide
Refer to the Quick Troubleshooting Guide below before contacting your agent for support.
Problem Possible Causes Remedy See also
Stacker does
not turn on
Key switch in OFF
position Insert key and turn clockwise to
turn the stacker on
§2.1.2
⑥
Key-switch 1030381514
EMERGENCY STOP
button depressed Pull the EMERGENCY STOP
outwards to enable the power
§2.1.3
⑩
E-Stop 1030381516
Flat batteries
Check battery indicator and
recharge batteries if necessary
§2.1.2
⑦
Indicator 1030381528
Faulty/blown fuse Check fuses
§4.4.7
Motor fuse 1030381544
Controller fuse 1030381545
Stacker is in
CHARGE mode
Disconnect the charging lead
Charger 1030381519
Charging lead 1030381534
Stacker turns
on, but forks
do not lift
Hydraulic fluid
level too low Check the level of hydraulic fluid
and top-up if necessary
§4.5.1.1
Stacker is
overloaded Remove excess material from
the pallet
§1.5
4.2 Cleaning
Before cleaning the Quikstak, park it in a safe location as per §2.6 .
The Quikstak should be cleaned with a microfiber cloth and a non-flammable cleaning
solution. The exterior of the Quikstak may be cleaned with a low-pressure water jet, but it
should not be directed directly onto the controls or around the edges of the outer cover.
Do not clean the Quikstak with a waterblaster or high-pressure water jet.
If using flammable cleaning agents, ensure there are no ignition sources within 4 metres.