13
SimpliFire • SF-INS30-BK • 2042-980 Rev. B • 12/18
ICON
TITLE
FUNCTION
REMOTE LCD
DISPLAY
FIREPLACE RESPONSE
POWER
The POWER button will turn the
fireplace on. It will also put the
fireplace in a standby mode.
This will turn off all functions at
once but will hold the settings in
memory except Heater function.
The unit will turn on at the same
settings by pressing the power
button again.
LED illuminates and
displays flame status
Icon and temperature
set point.
Fireplace emits single audible beep
to confirm command to transition to
ON or STANDBY state
FLAME
By pressing the FLAME button,
the unit will cycle through four
flame effects.
LED illuminates and
displays flame status
icon.
Fireplace emits single audible beep
to confirm command to transition
between four FLAME states.
HEATER
Press Heater button once heater
turns on heat setting 1. (LOW)
One LED illuminates.
Fireplace emits single audible beep
to confirm command.
Press Heater button twice turns
heater on heat setting 2. (HIGH)
Two LED’s illuminates.
Fireplace emits single audible beep
to confirm command.
Press Heater button again turns
heater OFF.
No LED’s illuminate.
Fireplace does not make audible
beep.
THERMOSTAT
Pressing the Temperature button
adjusts the heater’s response
to the ambient temperature
conditions in the room.
Temperature adjusts from 16 °C
- 28 °C (60 °F - 82 °F). Power
button must be on to set from °C
to °F. Hold for 3 seconds and the
LED display from °C to °F.
Remote displays
the temperature. If
in Stand-by mode,
temperature displays
but cannot be
adjusted.
Fireplace emits single audible beep
to confirm command to change
desired temperature set point.
TIMER
Pressing the Timer button sets
the time desired for the fireplace
to run. The Timer can be set from
.5 hour up to 9 hours in 1 hour
increments.
Remote will display
the time setting
selected. If no timer
is set, there will be no
indicator.
Fireplace will emit single audible
beep to confirm command to
desired timer setting.
B. Operating by Remote Control
• Make sure batteries are properly installed in Remote
Control.
- Battery requirements 2 x AAA batteries
(included)
•
The effective range of the remote is up to 13 ft.
•
The remote control must be within the 13 ft. range and
also be pointed directly at the face of the appliance.
For best results, position the remote control within 45
degrees of the face of the appliance
C. Resetting Temperature Cutoff Switch
The heater is protected with a safety device to prevent
overheating. Should the heater overheat, an auto-
matic cutoff will turn the heater OFF. It will not turn ON
automatically without being reset. If it overheats for any
reason, it can be reset by:
1. Turn appliance to off
2. Unplug unit and wait 30 minutes
3. Plug in and turn on.
CAUTION: If appliance overheats repeatedly, discon-
tinue use and call customer / technical support.
CAUTION: If you need to continuously reset the heater,
unplug the appliance and call your customer/technical
support.
