9
SimpliFire • SF-FORMAT36 • 2042-950 Rev. B • 10/21
D. Location
Note:
If this appliance is installed in a bathroom, it must
be protected by GFCI receptacle or circuit. If receptacle
is used it must be readily accessible. This electrical ap-
pliance is not water tight. To prevent electrical shock, it
must be installed as to prevent water from entering appli-
ance. It must be installed away from showers, tubs, or
other water sources. Never locate the appliance where it
may fall into a bathtub or other water container.
When choosing a location for your appliance ensure that
the following general rules are followed:
• For best results, install out of direct sunlight.
• Power supply service must be installed within
proximity of electric appliance prior to finishing to
avoid reconstruction.
• Appliance should be mounted it is located outside
the swing arc of adjacent door.
• See Figure 3.3 and 4.1 to determine location of ap-
pliance installation.
E. Clearance to Combustibles
Minimum Clearance to Combustible Construction
Sides.......................0 in.
Floor........................0 in.
Top..........................0 in.
Back........................0 in.
Front..................... 36 in.
See Figure 3.3.
F. Electrical Supply Circuit Requirements
Plan the location of the appliance so that it will have ad-
equate electric power. A 15 AMP, 120VAC/60Hz circuit
is required. Additional appliances on the same circuit as
this appliance may exceed the current rating of that cir-
cuit. A dedicated circuit is not required, but is strongly
recommended to prevent circuit breaker trips or fuse
failure.
Mantel
Outside
swing arc
of adjacent
doors
min. 0 in.
min. 0 in.
Wall
Ceiling
min. 0 in.
min. 0 in.
Figure 3.3 Location and Clearances Requirements
Note:
If using the supplied power cord, choose a loca-
tion near an outlet so an extension cord is not required.
WARNING! Risk of Fire!
Keep electrical cords, drapery,
furnishings or other combustibles at least 36 in. (914 mm)
from the front of the electric appliance, and away from the
sides or rear.
Note:
A wall swtich may be used on the circuit if desired.
