Simplified MFG REX2, Руководство пользователя

Страница: 13 / 14

At the TX end:
Is everything connected (Cat, HDMI, Power etc)?
Is the HDMI cable in the HDMI input of the TX? We often
use a loop out, make sure the input is not in this port.
What are the lights where the Cat cable plugs into doing?
Is the Green Lit Solid?
Yes, good! Flashing or off
the category cable is poor.
This can be the termination
(check the manual for wiring
termination), poor wire, or
interference from being run
poorly
Is the Amber Lit Solid?
Yes good! Flashing slowly
means no HDCP, off means
no signal at HDMI port(s)
How to use and trouble shoot
Simplified MFG Extenders
Typical Extender use
At the RX end:
Is the Green Lit Solid?
Yes, good! Flashing or off
the category cable is poor.
This can be the termination
(check the manual for wiring
termination), poor wire, or
interference from being run
poorly
Is the Amber Lit Solid?
Yes good! Flashing slowly
means no HDCP, off means
no signal at HDMI port(s)
Other Techniques:
Make the circuit simpler. Move the source near the
display or the display near the source and see if it
works with a short HDMI cable. You can use this to
verify the HDMI cables work as well. Add components
until the system fails.
Use a known working run of category cable across the
floor and see if behavior changes.
It is often the case that the display ’ s setting can cause
odd/poor behavior. Consult the display ’ s tech
resources. Also, it is possible we have seen the issue
and may have a tech paper on this.
Not a bad idea to keep the following on your service
vehicle:
•
Test source like an AppleTV or signal generator
•
Known working HDMI cables
• Known working terminated Category cable
• SP12S splitter for clocking issues, etc.
Simplified MFG • 550 W Baseline Road Ste 102
-
121 • Mesa, AZ 85210 • www.simplifiedmfg.com • 833
-
HDMI
-
411 (436
-
4411)