RECOMENDED TOOLS
ALLEN KEY
A size 7 or 8 allen key required for tightening set
screws in the fi ttings
SAW TO CUT TUBE
• Chop Saw
• Band Saw
• Hack Saw
DRILL
• Hammer drill may be needed when drilling
into brick or concrete
NEEDED MATERIALS
SELF DRILLING SCREWS (NO. 12) OR
MULTI-GRIP POP RIVETS
For attaching handrail to brackets
MOUNTING HARDWARE FOR BASE
FLANGES
• 6mm For Wall Mounts
• 12mm For Base Flanges
RECOMENDATIONS:
• Lag Screws
•
Tapcons
•
Bolts
• Chemical Anchors
(please refer to a fi xing supplier for advice on selection)
INSTALLATION TIPS
• Cut the tube at the job site.
• Use the type
$(
base fl ange when fi tting to concrete, avoiding installing close to the
edge and instead of core drillng to prevent rust to upright.
• Center uprights not to exceed 1.8m when loadings not exceeding 0.74 KN / m are
required.
• Uprights must be off set from corners and bends in the railing.
For assistance visit: www.simplifi edsafety.co.uk/solutions/dda-handrail/ or call 0844 335 8460
2
