26
CUTTING HEIGHT ADJUSTMENT
The cutting height adjustment pin (A, Figure 33) controls
the mower cutting height. The cutting height is
adjustable between 1-3/4” (4,4cm) and 5” (12,7cm) in
1/4” (0,64cm) increments.
Depress the deck lift foot pedal (B), placing the majority
of the force on the top edge of the pedal until it locks into
the “TRANSPORT” position. Place the cutting height
adjustment pin in the desired cutting height. Depress the
deck lift foot pedal, placing the majority of the force on
the bottom edge of the pedal to release the pedal from
the “TRANSPORT” position.
Figure 33. Cutting Height Adjustment
A.
Cutting Height Adjustment Pin
B.
Deck Lift Foot Pedal
C.
Cutting Height Selection Decal
DECK LEVELING ADJUSTMENT
1. Park machine on a flat, level surface. Disengage the
PTO, stop the engine and engage the parking brake.
Rear tires must be inflated to 15 psi (1,03 bar); front
tires to 25 psi (1,72 bar).
2. Lock the deck lift pedal in the TRANSPORT position.
Place the deck height adjustment pin in the 4" posi-
tion and lower deck the lift pedal until the arm con-
tacts the pin.
3. Place 2 x 4 blocks under each corner of the mower
deck with the 3-1/2” sides being vertical. Place a 1/4”
(0,64cm) thick spacer on top of the rear 2 x 4 blocks.
See Figure 34.
Figure 34. 2 x 4 Locations
Measure 1st
Adjust Here
Measure 2nd
Figure 35. Spring Rod Adjustment
4. See Figure 35. Measure the distance between the lift
pivots and the lift rod pivots. Adjust the 5/8” hex nuts
on either side of the front lift rod pivot until the meas-
urements are equal.
WARNING
Before checking mower, shut off PTO and engine.
Allow all moving parts to stop. Remove ignition
key, then disconnect the spark plug wire and
fasten it away from the spark plug.
A
B
C
Troubleshooting, Adjustment & Service