Simplicity AGCO Allis 400 Series, Руководство по обслуживанию и ремонту

Страница: 37 / 136

4 Adjustments
Mower Adjustments
4 - 6
*2397
Figure 11. Transport Height Adjustment
A. Spacers
C. Nut
B. Rear Mower Rollers D. Rear Trailing Arms
Figure 10. Front-To-Back Leveling
A. Adjustment Nut
D. Leveling Rod
B. Rear Nut E. Jam Nut
C. Bracket
*2397
Front-To-Back Leveling
1. Make sure mower is level side-to-side and that rear
rollers are on the ground.
2. Position blade(s) front-to-back. Measure the distance
from the ground to front tip of blade(s), and from
ground to rear tip of blade(s).
On 30” mower, the front tip should be level to 1/8”
(3 mm) higher than rear tip.
On 34” mower, the front tips should be 1/4” (6 mm)
higher than the rear tips.
3. See Figure 10. Loosen jam nut (E). To lower front of
mower deck, loosen nut (B) which will lengthen level-
ing rod (D). To raise front of deck, shorten leveling
rod (D). When proper measurement is obtained, tight-
en nut (A) against bracket, then tighten jam nut (E)
against nut (A).
Transport Height Adjustment
Transport height should be adjusted so that rear mower
rollers are 1/8” - 1/4” (3-6 mm) above ground when
mower lift lever is in transport position. To adjust, per-
form both mower leveling procedures first, then do the
following procedure.
See Figure 11.
1. Park rider on a flat level surface.
2. Adjust Dial-A-Cut™ control so that front edge of
mower lift lever is aligned with 2-3/4” mark (34”
mower) or at 3” mark (30” mower) on the quadrant
scale.
3. Loosen nut (C) and position spacer (A) against rear
trailing arms (D). Position both the left and right side
spacers against trailing arms.
4. Tighten nut (C) securely.
5. Place mower lift lever in transport position. Rear
mower rollers should be 1/8” - 1/4” off ground. If not,
repeat steps 2 - 4.