Simplicity 653, Руководство оператора

Страница: 21 / 28

taken insure your tractor will be, ready go when
need it.
1. Drain the tank completely by cunning the tractor
until it stops. This may be easily done by removing the gas
line at the carburetor, and draining the tank through this
hose. If you desire, fuel may be stored in the tank or a
container if a good brand of gasoline stabilizer is
used. This from your Simplicity dealer,
prevents formation gum and varnish for up to one year,
providing easier starting and a clean fuel system.
2. Drain and refill the crankcase when the engine is warm.
See “Maintenance”.
3.
Remove spark plug, one ounce of oil into
cylinder through plug hole. Crank engine a few times to
distribute oil and reinstall the plug.
4. Clean dirt and chaff from cylinder head fins and engine
housing.
5. Grease all and apply oil to all points shown in
“Maintenance”.
6.. Block the machine up off the wheels to relieve weight
and keep tires off a damp floor. Protect the tires from pro-
longed exposure to direct sunlight.
7. Store the machine in a dry place indoors.
STARTING AFTER STORAGE
1. Remove the spark plug and wipe dry. Crank the engine
a few times to blow the excess oil out of the plug hole.
install the plug.
2. Fill the fuel tank with fresh gasoline. (Unless
a fuel stabilizer has been used.)
3. Service the air cleaner. See “Maintenance”.
4. Check the crankcase oil level and replenish if necessary.
See “Maintenance”.
5. Start the engine outdoors or in a well ventilated area.
DO NOT run the engine at high speed immediately after
starting.
6. Inflate the front to 12.15 PSI and rear to PSI.
REPLACEMENT PARTS
Replacement parts for your Simplicity equipment should
be purchased from your Simplicity dealer. Be prepared to
give him the tractor name, model and the ID number
found on the plate pictured below.
USE ONLY SIMPLICITY BELTS AND BLADES.