Simplicity 5900660, Руководство оператора

Страница: 29 / 45

26
www.simplicitymfg.com | www.snapper.com
Maintenance
CHECK TIRE PRESSURES
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that
these pressures may differ slightly from the “Max
Inflation” stamped on the side-wall of the tires. The
pressures shown provide proper traction, improve cut
quality, and extend tire life.
ADDING FUEL
To add fuel:
1. Stop the engine and allow to cool for at least 3
minutes.
2. Remove the fuel cap (see A, Figure 24).
3. Fill the tank to the bottom of the filler neck. This
will allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual
for specific fuel recommendations.
4. Install and hand tighten the fuel cap.
FUEL FILTER
The fuel filter is located in the fuel line between the
fuel tank and fuel pump. If the filter is dirty or clogged,
replace as follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled
fuel.
3. Using pliers, open and slide the hose clamps from
the fuel filter (C, Figure 24).
4. Remove the hoses from the filter.
5. Install the new filter in the proper flow direction in
the fuel line.
6. Secure with the hose clamps.
7. Reconnect the negative battery cable when
finished.
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the
area. Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread
hose clamps further than necessary. Ensure
clamps grip hoses firmly over filter after
installation.
Do not use gasoline containing
METHANOL, gasohol containing more than
10% ethanol, gasoline additives, premium
gasoline, or white gas because engine/fuel
system damage could result.
Figure 24. Maintenance
A. Fuel Tank Cap
B. Transmission Oil Caps
C. Fuel Filter
Tire Pressure
Front 40 psi (2,76 bar)
Rear 15 psi (1,03 bar)
Figure 23. Checking Tire Pressure
A
Regular Maintenance
B
C