Not for
Reproduction
13
Operation
Foot Pedal Adjustment
The deck lift foot pedal can be adjusted to accommodate the
operator’s height for optimal comfort.
To adjust pedal position:
1. Remove the foot pedal (A, Figure 7) from the pedal
mount tab (B).
2. Remove the pedal mount hardware (C) and rotate the
tab 180 degrees.
3. Reinstall the pedal mount hardware and tighten securely.
4. Reinstall the foot pedal on the pedal mount tab in the
proper orientation as shown in Figure 7.
Figure 7. Foot Pedal Adjustment
A. Deck Lift Foot Pedal
B. Pedal Mount Tab
C. Pedal Mount Hardware
D. Optional Position
A
B
C
D
C
Figure 6. Mowing Height Adjustment
A. Cutting Height Adjustment Pin
B. Deck Lift Foot Pedal
C. Deck Lift Lock lever
A
B
Mowing Height Adjustment
The cutting height adjustment pin (A, Figure 6) controls
the mower cutting height. The cutting height is adjustable
between 1-1/2” (3,37 cm) and 4-1/2” (11,47 cm) in 1/4”
(0,64 cm) increments.
1. Depress the deck lift foot pedal (B) until it locks into the
4-1/2” (11,47 cm) position.
2. Place the cutting height adjustment pin in the desired
cutting height.
3. Depress the deck lift foot pedal then pull the lock lever
(C) toward the rear of the machine to release the lock.
4. Release the deck lift foot pedal until it comes to rest
against the cutting height adjustment pin.
Figure 5. Seat Adjustment
A. Seat Adjustment Lever
Seat Adjustment
See Figure 5. The seat can be adjusted forward and
backward. Move the lever towards the left, position the
seat as desired, and release the lever to lock the seat into
position.
Figure 4. Checking Tire Pressure
Check Tire Pressures
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires. The pressures shown
provide proper traction, improve cut quality, and extend tire
life:
A
Tire
Pressure
Front
25 psi (1,72 bar)
Rear
15 psi (1,03 bar)
Содержание 5900506
Страница 41: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 44: ...N o t f o r R e p r o d u c t i o n OPERATOR S MANUAL...