Simplicity 5100723, Руководство оператора

Страница: 27 / 44

25
Maintenance
Tire Pressure
Front 25 psi (1,72 bar)
Rear 15 psi (1,03 bar)
Figure 14. Checking Tire Pressure
CHECK TIRE PRESSURES
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that
these pressures may differ slightly from the “Max
Inflation” stamped on the side-wall of the tires. The
pressures shown provide proper traction, improve cut
quality, and extend tire life.
CHECKING / ADDING FUEL
To add fuel:
1. Stop the engine and allow to cool for at least 3
minutes.
2. Remove the fuel cap (see Figure 1).
3. Fill the tank to the bottom of the filler neck. This
will allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual
for specific fuel recommendations.
4. Install and hand tighten the fuel cap.
FUEL FILTER
The fuel filter is located in the fuel line between fuel
tank and carburetor, near the fuel pump. If filter is
dirty or clogged, replace as follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled
fuel.
3. Using a pliers, open and slide hose clamps from
fuel filter.
4. Remove hoses from filter.
5. Install new filter in proper flow direction in fuel line.
6. Secure with hose clamps.
7. Reconnect the negative battery cable when
finished.
CHANGE OIL & FILTER
1. Warm engine by running for a few minutes. (Refer
to the engine operator’s manual for oil & filter
replacement instructions.)
2. Remove the oil drain hose (A, Figure 15) from the
cable clamp (C) on the right-hand side of the
frame and route the hose towards the rear of the
machine as shown in Figure 15.
3. Place a small pan under the oil drain hose to
catch the oil. Using the appropriate tools, remove
the cap (B, Figure 15) from the oil drain hose (A)
and drain the engine oil.
4. After draining, replace the cap and wipe up any
spilled oil. Reinstall the oil drain hose into the
cable clamp to retain the hose during normal
operation.
5. Place an absorbent shop cloth under the engine
oil filter. Remove the engine oil filter and replace
with a new one.
6. Remove the shop cloth and wipe up any spilled
oil.
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the
area. Avoid over-filling and wipe up any spills.
Do not remove fuel filter when engine is hot, as
spilled gasoline may ignite. DO NOT spread
hose clamps further than necessary. Ensure
clamps grip hoses firmly over filter after
installation.
Do not use gasoline containing
METHANOL, gasohol containing more than
10% ethanol, gasoline additives, premium
gasoline, or white gas because engine/fuel
system damage could result.
Regular Maintenance
Figure 15. Engine Oil Drain
A. Oil Drain Hose
B. Cap
C. Cable Clamp
C
B
A
Not
for
Reproduction