Installation Front Cut Riders
NOTES
1. Two spacers are packaged with the turbo
blower. Installation on the Front-Cut Rider
requires use of the
spacer (see step 14).
The
spacer will not be used.
2. The replacement right hand belt cover
with
for the right hand idler pulley (see step
is
packaged with the collection system.
INSTALLATION
1. Remove right hand mower belt cover by
removing flat washer and flange nut (A) and
front taptite screw (B). Loosen hardware at
center location (C). Belt cover can bediscarded
as new belt cover and arbor cover will replace
original cover. Save all hardware for installing
new cover.
2. Remove the deflector mounting hardware and
reinstall in deflector for future use. Deflector
must be reinstalled if turbo blower is removed
from mower deck.
Figure 1. (Later
Shown)
A. Flange Nut
B.
Screw
Mounting Hardware Center Location
WARNING
Use caution when moving spring-loaded idler
pulley. Spring tension isstrong. Do not remove
belt from spring-loaded idler pulley. Remove
belt from left and right hand pulleys.
3. Pull spring-loaded idler pulley away from belt
and remove belt from right hand arbor pulley
and idler pulley.
4. Remove the idler pulley
(installed
from the top) and install new
from the bottom. Pulley bracket
mounting hardware may need to be loosened to
install
(A) from bottom. Install
existing flat washer
on top of bracket, pulley,
existing flat washer(B),
nut
(D) to secure capscrew. Install large washer(E)
onto capscrew.
(A), lockwasher
nut (D), and large washer(E) are packaged with
the collection system.
NOTE
Existing flange nut will be used in step 15 to
secure new belt cover.
I
F
2.
A.
B. Flat
Washer (Existing)
C.
D. Nut
E. Large Flat Washer,
