5
Wireless radio control console
The wireless radio control console is used for the remote control of the LED kit H/T
(within a range of 10 metres).
Setting the DIPs for HF receiver link and wireless console :
• Disconnect the power supply before performing this operation.
• Recognition between the console and the HF receiver on the board is established
via DIPs in order to avoid having the LED kit H/T controlled by another wireless
radio console that is not already recognised.
• Open the console. Position the first eight DIPs as desired on the HF receiver board
on the H/T LED board and the DIPs for the wireless console (placing them in the
same position as the eight DIPs on the two terminal blocks). DIPs 9 and 10 (on the
console only) must never be modified : position DIP 9 to ON and DIP 10 to OFF.
• Close the console and press a button. The HF receiver on the H/T LED board
is then configured so that it will only work with the console with the same DIP
configuration. This sequence is saved in memory even in case of a power failure.
• Change the console batteries every two years, on average : 12 V battery (type
A23).
• Note : a second HF radio control console may be used, in which case the DIPs on
the consoles and HF receiver board must be set to the same positions.
• Warning : the remote control may not function correctly in the presence of a strong
electromagnetic field.
(*) The HF radio receiver can be detached from the box to obtain better reception or to make it easier to
install the box. The HF radio receiver must not be moved further than 50 cm from the box. The receiver is
not watertight.
HF receiver board
HF console
Dips
To HF
receiver*
HF receiver
