Operating Instructions for the Palm LDB Version 1.40
8
Version: June 2004
Now indicate the Palm user for whom the locking plan is to be exported and
whether you want to end
the HotSync manager
automatically after
transmission. The last
setting is important if you
subsequently want to
work with the
ConfigDevice on the
same serial interface. If
you want to synchronize
the time of day on the PC
with that on the Palm,
activate
Set time on the
Palm
and confirm with
OK
. We recommend that
you always set the time.
Make sure that the time of day and date in the Palm agree with the real
time and date. It may be that the Palm does not automatically switch over
to daylight saving time or standard time.
Carry out a HotSync procedure. The locking plan will now be transmitted to
your Palm.
You must end the PalmLDB on the Palm to export data from the LDB or
LSM to the Palm or to import data from the Palm to the LDB or LSM.
To set the baud rate, proceed as described in the following. In the task
bar, click the
symbol and then Configure... If you are using the
PalmCD2, you should normally set the speed to "as fast as possible" in the
Local tab. If there are problems during the synchronization, we
recommend that you reduce the baud rate.
After you export the locking plan to the Palm, you should not make any
further changes in the locking plan software LDB until the import, because
otherwise there could be conflicts, or so-called inconsistencies.
