Digital Half Cylinder
Page 6
Warning Level 3 (SW version 10.3 and later)
If you continue to ignore the backup battery warning, either the door can be used
50 more times or the cylinder switches off after 4 - 5 weeks if there is no further op-
eration. In both cases, the cylinder switches into the so-called storage mode. After
this, you can only open the cylinder with the programming device.
4.2
Transponder
If the transponder battery voltage is coming to an end, eight short signal tones,
coming quickly one after another, sound each time the transponder is operated and
after the uncoupling.
&
Attention: Do not take out the transponder battery because this will probably
result in the loss of data.
See the “Transponder 3064” manual for more
information.
5.0 Battery Replacement
Only authorised personnel are permitted to replace the battery. Use only batteries
that are supplied by SimonsVoss.
1. Firmly hold the knob and remove the locknut on the back of the knob from the
knob with the special tool for half cylinders.
2. Use an authorised transponder to couple the cylinder and unscrew the knob
by turning it counter-clockwise. While doing this, you must firmly hold the
catch with your hand if the half cylinder is not installed. If the half cylinder is
installed, the catch is held by the stop within the lock.
3. Replace the main and emergency batteries. Make sure that the polarity is
correct.
4. Use an authorised transponder to couple the half cylinder and tightly screw
the knob in until the stop. Make sure that the knob is screwed on up to the
stop (important for the function). While doing this, you must firmly hold the
catch with your hand if the half cylinder is not installed. If the half cylinder is
installed, the catch is held by the stop within the lock.
5. Firmly hold the knob and use the special tool for half cylinders to firmly screw
the locknut onto the knob.
6. Now operate an authorised transponder and test the function.
Dispose of used batteries immediately, keep out of reach of children, do not open and
do not throw into a fire!
&
Reversing the polarity can result in damage to the locking cylinder. Incorrect
handling of the batteries used in this device can result in the risk of fire or
burns. Do not charge, open, heat to more than 100° C (212° F) or burn.
&
Never operate the cylinder without a main battery because otherwise the en-
tire power consumption of the cylinder runs over the backup battery.
