Simex SOC-8, Руководство пользователя, Страница: 3 / 16

User manual - MODULE SOC-8
1. BASIC REQUIREMENTS AND USER SAFETY
-
The manufacturer is not responsible for any damages caused by
inappropriate installation, not maintaining the proper environmental
conditions and using the unit contrary to its assignment.
- Installation should be conducted by qualified personnel . During installation all
available safety requirements should be considered. The fitter is responsible for
executing the installation according to this manual, local safety and EMC
regulations.
- The unit must be properly set-up, according to the application. Incorrect
configuration can cause defective operation, which can lead to unit damage or
an accident.
-
If in the case of a unit malfunction there is a risk of a serious threat to the
safety of people or property additional, independent systems and
solutions to prevent such a threat must be used.
- Neighbouring and connected equipment must meet the appropriate standards
and regulations concerning safety and be equipped with adequate overvoltage
and interference filters.
- Do not attempt to disassemble, repair or modify the unit yourself. The unit
has no user serviceable parts. Defective units must be disconnected and
submitted for repairs at an authorized service centre.
The unit is designed for operation in an industrial environment and must
not be used in a household environment or similar.
2. GENERAL CHARACTERISTICS
Module type
SOC-8
is designed for low power devices controlling via RS-485 interface.
SOC-8
can be applied to distributed controlling, visualisation and signalling systems. The
module can drives relays, bulbs, LEDs and other DC current devices with power voltage not
higher than 24V and current up to 0.5A. Full galvanic isolation allows safe operation of HOST
system without any risk of its faults caused by high voltage. All operating functions of
SOC-8
are available by RS-485 interface, and can be controlled by any visualisation software (using
MODBUS RTU protocol). Standard functions of Modbus protocol allows to change device
address and detects its type.
3. TECHNICAL DATA
Power supply voltage
16...
24
...30V DC (separated)
External fuse (required) T - type, max. 1 A
Current consumption 20mA typically
Number of independent outputs 8
Signalisation of output state LED light when output is active
3
!
!