User manual for digital indicator with U/I input SWE-73-A
Functions of the buttons while sub-menu and parameters choice:
Selection of sub-menu or parameter for editing. Name of selected item (sub-
menu or parameter) is displayed.
Operation of
[ENTER]
button depend on present menu position:
•
if the name of some sub-menu is displayed - enter this sub-menu; name
of the first parameter (or next level sub-menu) is displayed,
•
if the name of some parameter is displayed - enter the edition of this
parameter; present value of the parameter is displayed,
[ESC/MENU]
button allow user to exit present menu level and goes to upper
level menu (or measurement mode).
After about 1 min. since last use of the buttons, device exits the menu mode and
returns to the measurement mode (only if no parameters are in editing mode).
7.2.
PARAMETERS EDITION
To start edition of any parameter user should select name of desired one using
[^] [v]
buttons and then press
[ENTER]
.
7.2.1.
Numeric parameters (digit change mode)
Numerical parameters are displayed as decimal numbers. The mode of its new value
entering depends on chosen edit method ( see parameter „
Edit
”).
In mode “by digit” („
Edit
”=”
dig
”) pressing one of the keys
[^]
or
[v]
causes change of
current position (flashing digit) or the sign (+/-). Short pressing of the
[ENTER]
button causes
change of the position (digit).
Press
[ENTER]
at least 2 seconds to accept the changes, after that question
”SEt?”
is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and story it
in EEPROM) press
[ENTER]
button shortly after
”SEt?”
is displayed. To cancel the changes
press
[ESC]
button shortly after
”SEt?”
is displayed. After that device returns to the menu.
7.2.2.
Numeric parameters (slide change mode)
In “slide change” mode („
Edit
”=”
Slid
”), buttons
[^]
and
[v]
has different functions.
To increase edited value press (or press and hold)
[^]
button only, the increasing became
quickest as long as button
[^]
is pressed.
To slow down the increasing, button
[v]
can be
used. If
[v]
is pressed shortly (and button
[^]
is still pressed), increasing slow down for
a moment only, if
[v]
is pressed and held while button
[^]
is still pressed the increasing slow
down and will be kept on lower speed.
To decrease edited value press (or press and hold )
[v]
button only. The decreasing
became quickest as long as button
[v]
is pressed.
To slow down the decreasing, button
[^]
can be used. If
[^]
is pressed shortly (and button
[v]
is still pressed), decreasing slow down for
a moment only, if
[^]
is pressed and held while button
[v]
is still pressed the decreasing slow
down and will be kept on lower speed.
Press
[ENTER]
at least 2 seconds to accept the changes, after that question
”SEt?”
is
displayed, and user must to confirm (or cancel) the changes. To conform changes (and story it
15
i
ENTER
MENU
ESC
