Sime MURELLE EV HE 30, Инструкция пользователя

Страница: 7 / 16

7
1.3.2 Regulation
C.H. temperat ure (fig. 25)
To set the temperature of the water for
heating, press the key
of the controls
(2). The first time the key is pressed, the
SET of heating circuit 1 is selected. The
second time it is pressed, the SET if se-
cond zone fitted is selected. The display
will be as shown in the figure. Change the
values with the key
5
3
1
2
4
and
5
3
1
2
4
.
Standard visualisation will return to the
display by pressing the key
again, or
after 10 seconds if no key is pressed.
Regulation of the external
sensor (fig. 25/a)
If an external sensor is installed, the
value of the output temperature is au-
tomatically chosen by the system, which
quickly adjusts the environmental tem-
perature on the basis of the external
temperature.
If you wish to change the value of the
temperature, increasing or decreasing
that calculated automatically by the elec-
tronic card, proceed as indicated in the
preceding paragraph.
The level of various correction of a value
of temperature proportional calculated.
The display will be as shown in fig. 25/a.
1.3.3 Regulation D.H.W.
temperat
ure (fig. 26)
To set the desired temperature of the
D.H.W., press the key
of the controls
(pos. 2). The display will be as shown in
the figure.
Change the values with the key
5
3
1
2
4
and
5
3
1
2
4
.
The display will return to the standard
visualisation by pressing the key
again, or after 10 seconds if no key is
pressed.
1.3.4 To switch off the bo
iler
(fig. 24)
In the case of a short absence, press the
key
5
3
1
2
4
of the controls (pos. 2).
The display will be as shown in the fig. 24.
In this way, leaving the electricity and
the fuel supply connected, the boiler is
protected from frost and from the pump
becoming jammed.
If the boiler is not used for a prolonged
period, it is advisable to disconnect the
electricity supply, by switching off the
main switch of the system, and to clo-
se the gas tap and, if low temperatures
are expected, to completely empty the
hydraulic circuits to avoid pipes being
broken by the formation of ice in the pi-
pes.
Apre
2 2
2
Circuito
riscaldamento 2
Circuito
riscaldamento 3
(impianto tre
zone)
Fig. 25
Apre
2 2
2
Circuito
riscaldamento 2
Circuito
riscaldamento 3
(impianto tre
zone)
Apre
2 2
2
Circuito
riscaldamento 2
Circuito
riscaldamento 3
(impianto tre
zone)
Fig. 26
Fig. 25/a
Heating circuit 2