Sime Brava One 25 OF ErP, Руководство по установке и обслуживанию

Страница: 20 / 29

76
EN
Type No. Description Range U/M Step Default
tS 3.0 Maximum domestic hot water temperature 35 .. 67 °C 1 60
tS 3.5
Digital / analogue Pressure switch
0 = water pressure switch
1 = water pressure transducer
2 = water pressure transducer (only pressure displayed)
0 .. 2 - 1 0
tS 4.0 Modulating Pump Speed
-- = No modulation
AU = Automatic 30
.. 100
% 10 AU
tS 4.1 ∆ T Modulating pump delivery/Return 10 .. 40 % 1 20
tS 4.7
System pump forcing (only in winter mode)
0 = Disabled
1 = Enabled
0 .. 1 - 1 0
RESET
tS 4.8 INST Parameter set to default 0 .. 1 - - 0
In the event of a fault/malfunction the message
“AL”
will appear
on the display alternating with the alarm number eg.
“AL 04”
(Domestic Hot Water Sensor Fault).
Before repairing the fault:
– disconnect the appliance from the mains power by setting the
main switch to "OFF"
OFF
Fig. 30
– as a precautionary measure, close the gas isolation valve.
Repair the fault and start-up the boiler again.
NB:
after having repaired the fault, when the alarm number
appears on the display together with the message RESET (see
figure), press the button o ( R ) for approximately 3 seconds
to start the appliance up again.
3.5 Fault / malfunction codes
Type No. Description
AL 01 Smoke thermostat
AL 02 Low water pressure in system
AL 04 Domestic hot water sensor fault
AL 05 Delivery sensor fault
AL 06 No flame detection
AL 07 Sensor or safety thermostat intervenes
AL 08 Fault in the flame detection circuit
AL 09 No water circulating in the system
AL 11 Gas valve modulator disconnected
AL 12 Incorrect configuration of the open /sealed chamber
AL 17
Fault regarding maximum deviation between the 2
NTC heating sensors
AL 28 Maximum number of consecutive releases
AL 37 Fault due to low network voltage
AL 40 Incorrect network frequency detected
AL 41 Flame loss more than 6 consecutive times
AL 42 Button fault
AL 43 Open Therm communication fault
AL 44 Anomaly inside electronic board
AL 62 The self-calibrating procedure must be carried out
AL 72 Incorrect positioning of the delivery sensor
AL 74 Fault in the 2nd element of the delivery sensor
AL 80 Anomaly in gas valve control line
AL 81 Block due combustion during start-up
AL 83 Irregular combustion (temporary error)
AL 88 Anomaly inside electronic board
AL 96 Block due to clogging in smoke outlet