SimCom SIM900D EVB, Проектирование аппаратного обеспечения

Страница: 30 / 63

SIM900D Hardware Design
Table7: Specification of recommended battery pack
Items Description
Battery type Li-ion
Manufacturer Jiade Energy Technology
Normal voltage 3.7V
Capacity NORMAL 1100mAh
Charge Voltage 4.200±0.050V
Max Charge Current 1.0C
Charge Method CC / CV (Constant Current / Constant Voltage)
Max Discharge Current 1.0C (for continuous discharging mode)
Discharge Cut-off Voltage 3.0V/ cell
Internal resistance Initial ≤ 130m Ω
3.5.3 Implemented charging technique
SIM900D has battery charging function. There are three pins related to the battery charging function: VCHG,
VBAT and TEMP_BAT/ADC0 pins. The VCHG Pin is driven by an external voltage, system can use this Pin to
detect a charger supply and provide most charging current through SIM900D module to battery when charging is
in fast charge state. The VBAT gives out charging current from SIM900D module to external battery.
TEMP_BAT Pin is for user to measure the battery temperature. Just let this Pin open if battery temperature
measurement is not your concern.
So it is very simple to implement charging technique, user just needs to connect the charger to the VCHG Pin and
connect the battery to the VBAT Pin.
SIM900D battery charging happens after detecting charger supply and the battery present. If there is no charger
supply or no battery present, charging will not be enabled.
Normally, there are three main states in whole charging procedure.
z DDLO charge (Pull-up mode) and UVLO charge (Pre-charge mode);
z Fast charge;
DDLO charge and UVLO charge:
DDLO is the state of battery when its voltage is under 1.5V. And UVLO means the battery voltage less than 3.3V
and more than 1.5V. The battery is not suitable for fast charging when its condition is DDLO or UVLO. The
SIM900D provides a small constant current to the battery when the battery is between DDLO and UVLO. In
DDLO charging, SIM900D gives out 1mA current to the battery. And in UVLO charging, SIM900D provides
about less than 200mA current to the battery.
DDLO charging terminates when the battery voltage reaches 1.5V. UVLO charging terminates when the battery
voltage is up to 3.3V. Both DDLO and UVLO charge are controlled by the SIM900D hardware only.
SIM900D_Hardware Design_V1.04 2010.10.09
30