5
IQ Power Wireless Link
5201319 Rev B
Addressing of the IQ Power/IQ Easy devices allows for up to 10 devices to be set
and monitored by the Control Station. Follow the procedure below to address the
individual devices.
1. Plug the device to be addressed into the Control Station.
2. Once the device icon has appeared on the Control Station home screen, select
the device to open up the device page.
3. Tap on the page arrow until the screen with the device address setting appears.
4. Tap on the pencil next to the address setting to change the address. The
password screen will appear. Type in the password given to the Control Station,
then tap on the address number (1-10) to be assigned to the device connected
to the Control Station.
5. Once the address has been assigned, unplug the device from the Control
Station.
6. Repeat the process for each device being connected to the Control Station.
For more detailed instructions, please refer to the IQ Power Control Station
instruction manual.
Control Station Wireless Configuration Set-up
Before operation the Control Station must be set for wireless operation. If Wireless
Mode is available, set Control Station to Wireless Mode. If Wireless Mode is not
available, but Legacy Mode is available, set Control Station to Legacy Mode. If
neither Wireless or Legacy Mode is available, this step can be skipped.
1.
The Control Station will start by displaying the Home Page. In the
upper portion of the display is an icon for System Settings (a gear). Tap
on the gear icon to open the System Settings page.
2. Tap on the pencil icon next to Wireless (or Legacy) Mode, see above.
3. Enter password.
4. Tap on Wireless (or Legacy) Mode, Yes to enable Wireless (or Legacy) Mode.
Wireless Mode sets digital communication to ensure reliable wireless operation.
Verify Bluetooth Communications
NOTE
– If multiple adapters are used with the system, they must all have
the same “Matching No.” on their label. If the numbers do not match, the
system will not communicate properly.
Before mounting all hardware in its desired location, communications between the
Bluetooth Adapters must be confirmed. Connect the Bluetooth Adapter labeled “for
Control Station” to the control station using the supplied cable. Next, connect the
Bluetooth Adapter labeled “connect to Hub” to the IQ Power Hub. Apply power
