9
IQ Power HL Power Supply
5201258 Rev. C
The remote control can be configured “normally off” or “normally on” by the
jumper setting (refer to Figure 4). To access the jumpers the cover will have to
be removed from the power supply. Disconnect all input power from the power
supply then remove the six screws securing the cover and slowly and carefully
remove the cover.
Remote Control Optocoupler Schematic
Figure 4. Jumper Position at J3 for Remote Control Operation
There is a ribbon cable connecting the face label on cover to the main circuit
board. Use care not to disconnect this cable. If cable becomes disconnected,
lift latches on sides of ribbon cable connector, insert ribbon cable fully into
connector and press latches back down.
