Page
8
of
12
Step 14
: Remove the front (wheel-side) puck
from the can housing assembly by removing
the 6 screws shown here.
Set the lower spring and spring mount aside.
You can leave the lower spring assembly
attached to the sensor arm, but be careful
not to bend the arm during installation.
Step 15
: Install the Thrustmaster Threaded
adapter onto the back (base-side) puck. Be
sure to align the key and keyway.
Then install and tighten the 3 M4 screws and
washers.
The threaded adapter should lightly press into the back
of the base-side puck.
