simasa.com
· 37
ENGLISH
5. How to use
5.1. Loading the wire coil.
WARNING:
Set the main switch to 0 position,
activate the trigger lock and
remove the battery.
5.1.1. Push the release lever until it is
caught by the release stopper.
5.1.2. Cut approx 20 mm
Note: the tip of the wire must be aligned;
otherwise, it can get caught when feeding it
into the RE-BAR tier.
5.1.3. Push the reel stopper to open the
reel stay.
5.1.4. Insert the wire coil with left side
inwards, with the wire-end upwards and
forward
Close the reel stay and secure the reel
stopper.
5.1.5. Insert the tip of the wire into wire
guide C, through the gap of the feeding
gears and all the way into the machine
arm. (max 70 mm).
If the window is dirty and it is difficult to
determine the position of the wire guide C,
clean the inside of window with a soft cloth.
5.1.6. Push the release stopper.
Make sure that the release lever is back in
original position and that the feeding gears
are clamping the wire.
5.1.7. Make sure that the wire is tight
and firm.
Prevent the wire from curling up behind the
wire coil. This may cause a jam.
Release stopper
Release lever
Reel stopper
!
Reel stay
Reel stopper
20 mm
Wire guide C
Wire guide
10-70 m
m
Using a wrong type o
f wire can
cause malfunction a
nd damage
the RE-BAR tier.
If the wire is corrode
d it can
damage the RE-BA
R tier even
if it is the right type.
Release stopper
Release
lever
Feeding gears
Presione el embrague hasta que
Содержание ATA 400 RE-BAR 25
Страница 1: ......
