1. From the backside of the case, take
out all the accessories as shown.
2. Included power cord and AC adapter
shown.
3. Use included hex wrench to remove
all six screws on top of the case and
remove top cover.
7. Place the secured bracket with fan
on the casing and tighten with a screw.
13. Turn the case upside down while
holding the hard drive in place, then
use four #6-32 x 6 flat head screws
to secure hard drive.
19. Place optical drive on the bracket
removed from Step 7.
20. Line up holes for optical drive and
secure it with screws.
21. Insert entire drive/drive bracket back
into the case.
22. Make sure two screws from the drive
brackets are installed.
23. Connect all wires for your system.
tighten the screws.
24. Place top cover back onto the case
then re-insert all six hex screws to
complete case installation.
14. Insert PCI card into the extender/riser
card assembly.
15. Remove expansion card slot cover
and insert the entire PCI/riser card
assembly into the motherboard.
Secure PCI card on the back of the
case with screw to complete installation.
16. Prepare for optical drive installation.
17. Take out the slim optical drive adapter
and the included M2 x 8 screws as shown.
18. Install adapter into the back of the
slim optical drive.
8. Prepare for motherboard installation.
9. Place motherboard into the case and
secure it by using four M3 x 6 screws
with washer head.
10. Remove optical drive bracket.
11. Prepare for hard drive installation.
12. Place hard drive into the case.
4. For additional cooling take out the fan
mounting bracket and the round rubber
spacers (40mm fan shown is sold
separately ).
5. Place the rubber spacers (4pcs) on
the fan as shown on the picture.
6. Then make sure the fan is securely
tightened on the bracket. (Two
40mmx40mmx15mm fans can be
installed on the bracket).
