Silvercrest SRR 3.7 B2, Руководство по эксплуатации

Страница: 20 / 158

GB
IE
16 SRR 3.7 B2
NOTE
If...
–
... the shaving result is noticeably poorer, ...
–
... you have to the shave the same spot repeatedly
to achieve a good result, ...
–
... the shave takes much longer than usual, ...
–
... there is visible damage to the shaving heads, ...
... the shaving heads/the cutting unit
2
must be replaced.
You can order the cutting unit
2
, incl. shaving heads from
our customer service (see order card).
To replace the cutting unit
2 proceed as follows:
1) Press the release button
4
so that the cutting unit
2
pops open.
2) Overstretch the cutting unit 2 a little so it can be pulled
upwards and off .
3) Fit the new cutting unit
2
onto the shaver. Ensure that it
snaps into place and is seated fi rmly.
Storage
CAUTION! MATERIAL DAMAGE!
Never store the shaver in the case
r
while the appliance is
charging. Risk of overheating!
■ Always replace the protective cap
1
onto the cutting unit
2
when
you are not using the appliance. Ensure that the corner with the
long plastic sleeve lies above the release button
4
. Otherwise,
the protective cap 1 cannot be fi tted.
IB_108312_SRR3.7B2_LB3.indb 16 16.03.15 09:25