Silvercrest SRH 5 A1, Инструкция по эксплуатации и правила безопасности, Страница: 16 / 62

GB
│
IE
│
NI
│ 13 ■ SRH 5 A1
FM radio operation (FM)
Automatic scan search (AMS)
♦ This device must be switched on. If necessary, briefly press the button
2
to
switch on the device.
♦ If necessary, briefly press
SOURCE /
3
several times until FM radio
mode and the frequency display in MHz is shown on the display
1
.
♦ Briefly press the
VOLUME
|
ENTER / SCAN
dial
6
to start the auto-
matic station scan. The display
1
now shows the message
Scanning...
. The
station scan stops at the next station with a sufficiently strong signal.
Storing stations automatically
The automatic station scan with station saving scans the entire frequency band
once and automatically saves the FM radio stations found as an
FM station list .
♦ Press the
VOLUME
|
ENTER / SCAN
dial
6
for approx. 2 seconds
to start the automatic station scan with station presetting. The display
1
now shows the message Scanning... FM and the number of found stations.
The scan progress is displayed as a progress bar. The FM radio stations
found are automatically stored in the station list on order of increasing
frequency. When the scan is finished, the first station in the station list is
automatically played back.
NOTE
► The automatic station scan replaces the stations already stored in the preset
spaces.
Selecting stations
♦ Press
PRESET
5
for about 2 seconds to call up the FM station list .
♦ Press
TUNE+
8
or
TUNE−
7
to select an FM radio station from the
station list.
Manual station scan
♦ Press the
TUNE+
button
8
for around 2 seconds to jump to the next availa-
ble station with a higher frequency.
♦ Press the
TUNE−
button
7
for around 2 seconds to jump to the next availa-
ble station with a lower frequency.
NOTE
► The frequency of the station is shown on the display
1
and the speaker
9
is switched off during station search.