Silvercrest SKD 2300 A1, Руководство по эксплуатации

Страница: 11 / 90

SKD 2300 A1
9
3. Press the “Reduce temperature” button 17
to lower the desired temperature to a
minimum of 5 °C (41 °F).
Selected specified temperature
20
is
shown in display 5 .
6.3 Setting the heat setting
The appliance has three heat settings:
– 1,000 watts
– 1,300 watts
– 2,300 watts
1. Press button 25 repeatedly until the
desired heat setting is set.
Selected heating level
11 is shown in
display
5
.
2. Press the fan button 15 to switch the fan
on or off.
If the fan is switched on, "Fan"
symbol
12 is shown in display 5 .
Note: The fan might make a slight noise,
but it does ensure better circulation of
the heated air.
6.4 Setting the heating time
The appliance has a timer for setting the
heating time to between 1 and 15 hours.
The appliance switches off automatically
once the heating time has expired.
1. Press timer button
18
repeatedly until
desired running time 19 is shown in
display
5
.
2. To switch off the timer, press timer
button 18 repeatedly until running time
19 is no longer displayed.
6.5 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Switch the mains switch
9 to " 0 " to
switch off the appliance.
2. Check whether the air inlet 6 or outlet 4
is obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
6.6 Frost protection
To prevent the temperature in a room falling
below 0 °C (32 °F), proceed as follows:
1. Press the button for selecting heating
level 25 repeatedly until "Frost
protection" symbol 13 appears in
display 5 .
As soon as the temperature in the immediate
vicinity of the appliance drops significantly
below 7
°C (44 °F), the heating
automatically switches on at the highest
setting.
As soon as the temperature rises to above
9 °C (48 °F), the heating switches off and
display
5 shows room temperature again.
2. To switch off frost protection, press the
button for selecting heating level 25
repeatedly until "Frost protection"
symbol
13
in display
5
disappears.
RP74308 Konvektor LB4 Seite 9 Mittwoch, 16. Mai 2012 3:20 15