GB/IE 23
Assembly
Remove all packaging material and all transport
protection locks from the unit.
Place the halogen heating unit on its rear side.
Guide the connecting cable
12
through the re-
cess
15
in the base
9
.
Loosen the two tommy screws
13
from the base
9
.
Place the base
9
so that the three screws fit perfect-
ly into the three cavities. Ensure that the connecting
cable
12
is routed through the lower recess
15
.
Attach the base
9
to the halogen heating unit
13
using the two tommy screws provided .
Guide the connecting cable
12
through the cable
clamp and the recess in the base
15
.
Preliminary measures before
start up
Unit setup
To guarantee safe and trouble-free unit operation, choose
a setup location which meets the following requirements:
- The floor should be firm, flat and horizontal.
- Observe the following minimum clearances
from the unit housing: 50 cm from its lateral side,
50 cm above, 50 cm from its rear side and 50
cm from its front side.
- Do not place the unit in a hot and wet or very hu-
mid environment or near combustible materials.
- The socket should be easily accessible so that
the mains connection cable can be easily dis-
connected if necessary.
A
B
C
D
E