11
SHBS 5 A1
GB
Comb attachment for the beard trimmer attachment
The comb attachment
12
has settings for 6 diff erent cut lengths (4 mm/6 mm/9 mm/12 mm/
15 mm/18 mm).
♦
Attach the comb attachment
12
from the front onto the beard trimmer attachment
7
and press
it down.
♦
To remove the comb attachment
12
press it forwards off the appliance.
Hair trimmer attachment
NOTE
►
Any hair to be cut should be clean and dry.
►
Brush the hair carefully through to remove any knots.
►
Place a hairdressing cape or cloth around your neck and throat to avoid cut hair ends
falling inside your collar.
►
Start by setting the comb attachment
11
to a longer length and reduce this in stages while
cutting the hair.
►
Please note that the corresponding cut length will only be achieved if the slide switch
2
is set to position 3 and the appliance is being held at right angles to the skin surface.
♦
Switch the hair and beard trimmer on by pressing the ON/OFF switch
3
.
♦
Run the hair and beard trimmer slowly through your hair.
♦
Hold the appliance so that the comb attachment
11
is as fl at as possible.
♦
Always cut from your neck towards the top of your head, or from your forehead and temples
upwards towards the middle of your head.
♦
Use the hair trimmer attachment
without the comb attachment
11
to cut the hair very short.
♦
You can use the slide switch
2
to fi nely adjust the cut length in three steps.
IB_96126_SHBS5A1_LB4.indb 11
IB_96126_SHBS5A1_LB4.indb 11
21.01.14 15:16
21.01.14 15:16