Silvercrest SDM 1500 B2, Руководство по эксплуатации, Страница: 67 / 90

■ 64
│
GB│MT SDM 1500 B2
2) Press the “Handle” release button and flip the handle upwards so that it
clicks into place.
3) Run the cable through the notch
0
on the rear of the handle so that the
cable does not hang down into the working area.
4) Insert the plug into the mains power socket.
5) Set the on/off switch
1
to “I”. The on/off switch
1
lights up, the red
POWER control lamp flashes.
6) Use the MODE button
!
to select the desired level of steam generation:
–
Press 1 x: low steam level, green control lamp
3
lights up.
–
Press 2 x: high steam level, red control lamp - lights up.
–
Press 3 x: no steam, standby, POWER control lamp lights up.
NOTE
► We recommend the high steam level especially for moisture- and heat-
resistant floor coverings, such as tiles.
► We recommend the low steam level especially for moisture- and heat-
sensitive floor coverings, such as parquet flooring.
7) Wait around 30 seconds while the appliance heats up.
8) Press the “Steam” button . . The appliance starts generating steam and,
after a short time, steam is emitted through the pad .
9) Wipe over the desired area.
If the water tank becomes empty during use:
NOTE
► Once the water tank has been pumped empty, the pump will continue
running a little while until the empty water tank is indicated by the simul-
taneous flashing of the red control lamp “high steam level”
-
, the green
control lamp “low steam level”
3
and POWER control lamp .
–
Press the “Steam” button
.
again to stop steam production.
–
Set the on/off switch
1
to “O”.
–
Remove the water tank , fill it and replace the water tank as
described in the section “Filling with water”.
–
Set the on/off switch
1
to “I”.
–
Select the desired steam level as described above and press the
“Steam” button
.
.