Silvercrest SDBK 2400 E4, Руководство по эксплуатации

Страница: 13 / 86

11
GB
9. Repeat steps 1 to 8 until no more resi-
dues are coming out.
10.Pull out the mains plug, allow the device
to cool down, and pour off any remain-
ing water.
9. Storage
DANGER!
~
Store the steam iron out of the reach of
children.
1. Set the temperature controller | 17 to
MIN.
2. Place the steam iron on the stand | 7 .
3. Allow the device to cool down.
4. Set the steam flow rate controller
| 3 to
.
5. Set the switch | 11 to the position if
appropriate.
6. Remove the iron from the stand | 7 and
pour off any remaining water through the
filling opening of the water tank (under
the lid
| 2 ).
7. Place the iron on the stand | 7 and set the
switch | 11 to the position .
8. FIGURE D: wind the power cable | 9
around the cable spool | 10 and fix it in
place using the cable clamp | 22 .
9. Store the iron and the stand | 7 in an up-
right position.
10. Disposal
This product is subject to the
provisions of European Direc-
tive 2012/19/EC. The sym-
bol showing a wheelie bin
crossed through indicates
that the product requires sep-
arate refuse collection in the European Un-
ion. This applies to the product and all
accessories marked with this symbol. Prod-
ucts identified with this symbol may not be
discarded with normal household waste, but
must be taken to a collection point for recy-
cling electric and electronic appliances. Re-
cycling helps to reduce the consumption of
raw materials and protect the environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
11. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
~
Do not attempt to repair the device your-
self under any circumstances.
Fault Possible causes/Action
No
function
• Connect the device to the
mains power supply.
• Use the temperature control-
ler | 17 to turn up the temper-
ature.
Little or
no steam
• Fill the water tank | 15 to at
least one quarter full.
• Switch on the steam flow
rate controller | 3
( ).
• Run the self-cleaning cycle.
Steam
burst is
not work-
ing.
• Fill the water tank | 15 to at
least one quarter full.
• Set the right temperature.
• Leave a pause of a few sec-
onds between steam bursts.
BB1$6B%XHJHOHLVHQB%ERRN6HLWH0RQWDJ$XJXVW