Silvercrest SBL TW9 A1, Инструкции по эксплуатации и безопасности

Страница: 19 / 65

19 GB/IE
Use Bluetooth
®
speaker via
AUX stereo jack
Note: Music playback via cable takes priority
over music playback via Bluetooth
®
. Music play-
back from a Bluetooth
®
source is therefore inter-
rupted once the jack lead
13
is plugged into the
jack
11
. The LED
2
lights up green.
Switch on the sound source.
If the Bluetooth
®
speaker is off, press and
hold the button
1
until the LED
2
LED
lights green and a signal tone sequence
sounds.
Start playback on the sound source and
adjust the volume to the highest possible vol-
ume. Adjust the volume on the speaker by
turning the volume control
3
clockwise or
anti-clockwise by using a finger.
Start playing music on the sound source.
Switching between AUX-in
connection and the Bluetooth
®
connection
To resume music playback via Bluetooth
®
con-
nection, please unplug the jack lead
13
from the
speaker. It will search for the previously paired
device (if any) and re-establish the Bluetooth
®
connection automatically.
Aux-in connection has a higher priority over the
Bluetooth
®
connection as following:
Once the jack lead
13
is plugged into the
jack
11
, the Bluetooth
®
wireless connection
is disconnected. The music playback is
switched to AUX-in only and the LED
2
lights up green.
TWS Pairing
This function is only available if two of these
speakers have been purchased.
Turn on both units of the speaker, make sure
both units haven't been connected to other
source devices via Bluetooth
®
.
Press the TWS button
7
on the speaker
which is default as the master unit. A beep will
sound. When pairing has been carried out
successfully, the white LED
4
of the connected
slave unit stops flashing and a sequence of
beeps will sound.
The master unit still flashing LED
4
waiting
to pairing Bluetooth, connect with your play-
back device. Now these two units can be
played and controlled synchronously during
the Bluetooth playback mode.
Press the TWS button
7
again to break
the current TWS connection, the white circle
light LED
4
of the connected slave unit
flashes and a signal of sound sequence.
Note: Which press the TWS button
7
will be default is master unit in Left channel,
slave unit is Right channel.
Note: TWS function only work on the same
model number with this product.
Cleaning
Switch the device off, remove all plugs, be-
fore cleaning!
Only clean the outside of the device using a
soft, dry cloth!
Storage during non-use
Store the product in a dry environment when
not in use. Protect it from dust and direct sun-
light. The rechargeable battery needs to be
charged regularly.
Troubleshooting
= Fault
= Possible cause
= Action
No functions
Battery drained.
Recharge the battery as described in
“Charging the battery“.