SilverCrest Wireless Headphones RFH 1863
English - 17
Powering the Transmitter Cradle by Using Batteries
The transmitter cradle battery compartment is located on the bottom.
Remove any cable connections and turn the transmitter cradle upside
down, holding it in your hand.
Open the battery compartment by slightly pulling from the latch of the
compartment cover. The cover can be opened and then removed.
Insert three AAA-sized batteries into the battery compartment. Note the
+ and – icons on the batteries and inside the battery compartment.
Place the battery compartment cover over the battery compartment so
that the locking nose of the cover is inserted into the corresponding
notch on the transmitter cradle. Next close the battery compartment
cover until it locks in place.
If you have inserted batteries into the transmitter cradle
and you connect the power adapter to the power
receptacle (3), battery operation will be disabled
automatically. This helps you to save battery power
whenever the device is connected to the mains via the
power adapter.
While the transmitter cradle is on battery power, it will not
charge the built-in headphone battery.
