PS2-WLC Controller
- 2 -
Note:
Please only use batteries or rechargeable batteries with a nominal voltage of 1.5 V.
Please ensure the batteries are always inserted according to the correct polarity. Replace
the batteries with the same brand or similar batteries.
There is a risk of explosion if the batteries are not replaced correctly.
Do not attempt to recharge a non-rechargeable battery. There is a risk of explosion.
Batteries / rechargeable batteries can be fatal if swallowed. Please store batteries out of
reach of small children. Seek medical help immediately if a battery has been swallowed.
Do not expose the batteries to heat or flames. Never short-circuit batteries; never try to
force open batteries; never attempt to recharge non-rechargeable batteries. Batteries may
otherwise explode and cause serious injury.
Never replace the batteries in a potentially explosive area. Sparks may be generated
while the batteries are being inserted or replaced which could cause an explosion.
Potentially explosive areas are often signposted as such, but not always. These include
filling stations, such as under below-deck areas on boats, fuel transmission stations, fuel
depots, areas in which the air may contain chemicals or particles such as grain, dust or
metallic powder, as well as all other areas in which you would normally be asked to switch
off the engine of your car.
6.
Switching on and off
The on/off switch is on the back of the device. To switch the unit off move the
switch to the “OFF” position and to the “ON” position to switch it on.
7.
Connecting the controller
The connection mode will initiate as soon as the
On/Off switch
on the underside of
the unit is switched to the ON position. The
RX-LED
and
M
ODE
-LED
lights will
light up briefly at the same time. If the
RX-LED
comes on, the device is trying to establish a
connection with the receiver. The
RX
LED
goes out as soon as a connection has been
established.
8.
Force connection
If several wireless controllers are connected at the same time, you can use the
force
connection method
to select a single controller.
Press the
C
ONNECT
button on the hand-held unit and then press the
C
ONNECT
button
on the receiver within 15 seconds to establish a connection. Now press the
L3
button
and the
S
ELECT
button on the hand-held unit and the
C
ONNECT
button on the
receiver at the same time for 15 seconds.
9.
Mode selection
Many games support an analogue controller which permit more precise input than with digital
controllers.
There must be a connection to the receiver before you can switch between the digital and
analogue modes. To do this, press the
A
NALOGUE
button . The
M
ODE
-LED
lights
up in analogue mode. The
M
ODE
-LED
is off in digital mode.
Note:
The default mode is digital.
Not all games support digital mode.
You may have to finish the game before switching between modes.
10.
Energy-saving mode
The unit is equipped with an energy-saving mode to conserve energy and prolong battery life.
This mode is activated in the following situations:
where no connection has been established between the unit and the receiver after 3
seconds
where the unit and receiver are connected but the unit has not been used for 3 minutes
where the connection between controller and receiver has been interrupted and no
connection has been established within 6 seconds
where you press the
C
ONNECT
button on the hand-held unit without pressing the
C
ONNECT
button on the receiver within 15 seconds.
If your unit is in the energy-saving mode, press either the
S
TART
,
L3
, or
R3
buttons to reactivate the controller.
11.
TURBO functions
With the TURBO function you can switch the
U
,
{
, X,
,
R1,
R2,
L1
and
L2
buttons
to the TURBO/
rapid fire
function
. The controller must be connected to the receiver to activate
or deactivate the TURBO function.
To activate:
Press and hold the
T
URBO
button
until the
RX-LED
comes on.
Then press the button for which you want to activate the
rapid fire function
.
To deactivate:
First press the button which you want to reset. Press and hold the
T
URBO
button
until the
RX-LED
goes out.
