- 5 -
Fixing the kitchen radio beneath a
wall cabinet
With the supplied mounting plate
q
you can
fix the kitchen radio below, for example, a
kitchen wall cabinet:
1. Determine a suitable location for the
kitchen radio.
2. Press the two retaining levers on the back
of the appliance down. Push the mounting
plate
q
back and remove it.
3. Hold the mounting plate
q
under the in-
stallation location. Thereby, the front edge
of the mounting plate
q
should be ap-
prox. 4 cm behind the front of the kitchen
cabinet (See fold-out illustration "B").
4. Mark the four points for the drillholes with
a pencil.
5. Using a spike, make a small depres
-
sion at the marking points. Firmly secure
the mounting plate
q
with the supplied
screws.
6. Hold the kitchen radio slanted, with the
two recesses in the retaining lugs on the
mounting plate
q
. Press the kitchen radio
upwards until it perceptibly engages.
Disassembly
• To disassemble the kitchen radio, press
the two retaining levers at the rear of the
appliance downwards. Then pull the ra-
dio out to the front and remove it.
• Unscrew the screws and remove the as
-
sembly plate
q
.
Setting up the kitchen radio
Do not set the kitchen radio up without the
mounting plate
q
. Otherwise the speakers are
covered and the sound is scarcely audible.
To fit the kitchen radio with the supplied
mounting plate
q
:
1. Simultaneously press the two retaining
levers on the back of the appliance down.
Push the mounting plate
q
back and re-
move it.
2. Push the two rear retainer lugs on the
mounting plate
q
into the recesses on the
lower side of the kitchen radio.
3. Press the mounting plate
q
firmly into the
appliance underside until it perceptibly
engages.
Providing mains power
• When you have completed installation of
the appliance, insert the plug into a mains
power socket. The display
o
is illumi
-
nated and the appliance tries to receive
an RDS signal to automatically adjust
the time and date.
•
For as long as the appliance waits for
the RDS signal, the display
o
shows
"
Please wait for setting thanks
". This
can take several minutes. To hide this no
-
tice, press the button MODE/
j
.
The Settings menu
Setting the time
Should this not succeed, you must set the
clock manually. For this, the radio cannot be
switched on (= automatic mode).
1.
In automatic mode press the button
MODE/
j
once. The time display
blinks.
2.
Press the buttons UP
/DOWN
1(
/
l
to set the time in minute intervals. Pressing
and holding the button changes the time
at ten-minute intervals.
3.
Press the button MODE/
j
once
again to save the time and switch to the
date setting.
If you do not press a button for 15 seconds
when making the settings, the appliance saves
the current setting and returns to automatic
mode.
Setting the date
1. In automatic mode press the button
MODE/
j
twice. In the display
o
appears "
01.01.2010
", the date display
flashes.
BDA_KH 2398 - DT-49029_6_uk.indd 5
22.06.2010 17:28:47