Silvercrest 78281, Руководство по эксплуатации

Страница: 19 / 28

- 16 -
Warning!
First remove the plug from the wall power socket be-
fore you lift the kettle from the base
4 . This avoids
the risk that any water splashing out could come
into contact with live electrical connections in the
base
4 , which could cause a short circuit.
Injury hazard!
For safety reasons, the lid 1 should not be opened
while the water is boiling or is very hot. There is a
risk of receiving severe scalds.
Cleaning and Care
Danger!
Do not open any part of the housing. There are no
operating elements inside. An open housing can
create the risk of a life-threatening electrical shock.
Never submerse any parts of the appliance in
water or other liquids! This can create the risk
of a life-threatening electrical shock if residual
liquid comes into contact with powered com-
ponents.
Before cleaning the appliance, ...
• first, remove the plug from the power socket and
allow the appliance to cool down completely.
• Clean the exterior surfaces and the power cable
with a slighly damp cloth. Be sure to dry the ap-
pliance well before taking it back into use.
• For stainless steel surfaces, you can use appro-
priate cleaning agents from a specialized dea-
ler.
• Never use any cleansers, abbrasive substances
or solvents. These can damage the appliance.
In the event of scale deposits
• Before descaling, remove the pourer sieve 8
(see chapter "Removing/replacing the pourer
sieve").
• Take any decalcifying agent used for kitchen
utensils (e.g. decalcifiers for coffee machines)
from a grocery shop. Proceed as detailed in the
instructions provided for the use of the decalc-
fying agent.
Removing/replacing the pouring sieve
• Open the lid 1 .
• Press from the front against the upper lug sitting
in the middle of the pouring sieve 8 and at the
same time hold it firmly by the flap.
• Remove the pourer sieve 8 .
• Clean the pouring sieve 8 with a lightly moiste-
ned dishcloth and under running water.
• After cleaning it, place the pourer sieve 8 from
inside against the opening. Ensure that the lower
and the lateral lugs grip the opening. Press the
pourer sieve
8 until the upper lug engages in
the opening.
• Should the scale deposits in the pourer sieve 8
be firmly settled, lay it in a water-vinegar solu-
tion, with a ratio of 6:1, for a few hours. The sca-
le deposits will dissolve themselves. Rinse the
pourer sieve
8 with lots of clear water.
Storage
Allow the appliance to cool off completely before
putting it into storage.
• Wind the power cable around the cable winder
5 under the base 4 .
• Store the appliance in a dry place.
IB_78281_SWKS2400B1_LB5.qxd 04.09.2012 16:19 Uhr Seite 16