Silvercrest 59345, Руководство по эксплуатации, Страница: 12 / 105

9
SEM 1100 A2
GB
CY
Heating-up after a long standing time / on the fi rst use
If you have not used it for some time, preheat the appliance as follows:
1) Fill the water tank
1
with water.
2) Place either the large
q
or the small espresso sieve
0
in the sieve carrier
w
.
3) Insert the sieve carrier
w
into the appliance by placing it at the marking
“INSERT” and then turning it anticlockwise to the marking “LOCK”.
4) Place a cup under the sieve carrier
w
.
5) Close the steam regulation knob
2
(turn it as far as it will go in the direction “ - “).
6) Switch the appliance on with the on/off switch
3
.
7) The red heating-up control lamp
i
glows.
8) Turn the rotary switch
5
to the position “ ”. The pump begins to pump water
into the appliance. As soon as water fl ows from the sieve carrier opening, turn
the rotary switch
5
back to the position “ ”.
9) As soon as the green heating-up control lamp
4
glows, turn the rotary switch
5
to the position “ ”. Allow the water to fl ow for about 1 minute. It may be that
you need to empty the cup in between. To do this, stop the process for a moment
by turning the rotary switch
5
back to the position „ “.
10) After approx. 1 minute turn the rotary switch
5
back to the position “ ”.
11) Wait until the green heating-up control lamp
4
glows again. The warming-up
is concluded. You can now prepare espresso.