33
GB/MT
Preparing for use
j
Set the time as described in the section on
“Setting the time”.
Q
replacing the picture
note:
The optimum picture format is 20 x 25 cm.
You should use a standard photo format of
20 x 30 cm and trim the picture to 20 x 25 cm.
j
Place the scale with the platform
2
facing
downwards on to a soft, scratch-proof surface.
j
Turn the catches
9
as shown in Fig. C I and
open the flap
8
.
j
Remove the originally supplied picture.
j
Insert the desired photo.
j
Close the flap
8
and turn the catches
9
as
shown in Fig. C II.
Q
Switching on your scales /
measuring your weight
tip:
Weigh yourself at the same time of day
(preferably in the morning) after visiting the toilet,
with an empty stomach and without clothing to
ensure that your results are compatible.
j
Place the scales down on a solid, flat horizon-
tal surface.
j
Do not place the scales on a carpet, otherwise
this may influence the results. If necessary you
can place a board on the carpet and place the
scales upon this. A solid floor covering is re-
quired in order to achieve correct weight meas-
urements.
j
Place a foot briefly, firmly and clearly audibly
on to the platform
2
. If present, the time dis-
play disappears. The self-setting symbol
appears briefly in the LC display
1
(see Fig.
D I). Then the value
appears (see Fig. D II).
j
The scale is now ready to measure your
weight.
note:
Ensure that the scale is always switched
on first and wait until the value
appears in the
LC display before you step on the platform
2
.
Otherwise the value “
” appears in the
LC display
1
.
j
Place even weight on each leg.
j
If at all possible stand on the same area of
the platform
2
each time and do not move.
Moving during the weighing process can lead
to discrepancies in the results.
The scale starts immediately with the measure-
ment. The measured weight appears in the
LC display, as shown in Fig. D III.
j
When the displayed weight flashes twice, the
measurement is complete.
note:
The scale is overloaded if the display
shows “
”. Do not exceed the maximum
load capacity of 150 kg (330 lb / 23 st).
j
Step off the platform
2
. The scale switches off
automatically after about 10 seconds. If the
time function is switched on, then the time
appears in the LC display
1
.
Q
Using the scale as a
picture frame
When using the scale as a picture frame, you have
the options of mounting the scale on a wall or
standing it up on the stand
10
.
mounting the device on a wall:
m
CaUtIon!
Check that the selected wall is
suitable for attaching the product before you start
mounting it.
rISk to LIFE From
ELECtrIC ShoCk!
Before mounting, check
the wall for concealed cables.
m
CaUtIon! WatEr DamagE!
Before
mounting, check the wall for concealed water pipes.
note:
To complete this step will require an electric
drill.
m
CaUtIon! rISk oF InJUry!
Refer to the
operating instructions for your electric drill.
j
Now insert the desired picture into the scale as
described in the section on “Replacing the
picture”.
j
Mark the positions of the drilled holes on the
wall (spacing: 16 cm).
54385_silv_Digitale_Personenwaage_Content_LB5.indd 33
08.03.11 11:18
