Silvercrest 296909, Руководство по эксплуатации

Страница: 13 / 52

■ 10 │
GB
│
IE
│
NI
│
CY
SEMK 105 A1
NOTE
► The first production phase may last a little longer than the following ones .
► The ice cubes do not reach full size until around the third production
phase, depending on the water and ambient temperature .
► The production time is dependent on the water and ambient temperature .
Stopping ice production
WARNING
► Drain the water from the water tank after a maximum of 24 hours .
Otherwise, bacteria can start to build up!
♦
Press the button to stop ice production . The control lamp flashes
green .
NOTE
► Depending on the ambient temperature, the ice cubes can be kept in the
appliance for up to 18 hours . If you would like to keep the ice cubes for
longer, place them into a freezer compartment in a suitable container .
♦
To switch off the appliance completely, remove the ice cubes and pull the
plug from the mains power socket .
♦
Allow the appliance to defrost and check whether there is any water left in
the rear part of the appliance . To do this, tip the appliance slightly forwards
so that the water runs into the water tank .
♦
To let the water out of the water tank , pull the appliance forward so that
it juts out over the edge of the worktop and you have access to the drain
opening on the underside of the appliance . Ensure, however, that the
front feet still have a firm foothold .
Hold a container that is suitably large to hold the expected amount of water
under the drain opening and pull out the cap .
♦
Once the water has drained out, push the cap firmly back into the drain
opening .