Silvercrest 276981, Руководство по эксплуатации

Страница: 35 / 144

■ 32 │ GB│IE SDB 1500 B2
7) Wait around 30 seconds while the appliance heats up.
8) Press the "Steam" button
6
. The appliance starts generating steam. After a
short time, steam is emitted through the underside of the steam broom .
9) If required, switch on the broom function by pressing the Start/Stop switch
"Broom" .
10) Wipe over the desired area.
NOTE
► Once the water tank is pumped empty, the pump will continue to run
for a short while. The empty water tank is indicated by the simultaneous
flashing of the control lamps 3 , ! and . .
If the water tank
empties during use:
–
Press the "Steam" button 6 again to stop steam production.
–
Set the On/Off switch
+
to "O".
–
Remove the water tank , fill it and replace the water tank as de-
scribed in the section "Filling with water".
–
Set the On/Off switch
+
to "I".
–
Select the desired steam level as described above and press the "Steam"
button
6 .
11) When you are finished treating all of the surfaces, press the "Steam" button
6
to stop steam production.
12) If you have activated the broom function, deactivate it by pressing the Start/
Stop switch "Broom" again.
13) Set the On/Off switch + to "O". The POWER control lamp 3 goes out.
14) Remove the plug from the mains power socket.
NOTE
► If you see streaks on the floor after cleaning with the appliance, this may
be due to the previously used cleaning fluids. Simply clean the floor again
using the steam mop. The smears should now be gone.