SBT 3.6 B1
GB
│
59
■
3) You can vary the cutting length to any one of the three settings. To do this, press
on the grooved area
on the eyebrow comb
so that the locking catch
is
pushed into the housing. Then push the eyebrow comb
to the cutting length
position which corresponds to the desired length. Use the cutting settings on the
eyebrow comb
as an orientation aid as well as the following table:
Setting
Hair length after cutting
1
approx. 3 mm
2
approx. 6 mm
3
approx. 9 mm
4) Push the on/off switch
3
in the direction of the attachment.
5) Start by combing the eyebrows
against
the direction of hair growth.
6) Run the precision trimmer
with the eyebrow comb
from the outer end of the
eyebrow towards the bridge of the nose.
7) When you are finished with the treatment, push the on/off switch
3
in the opposite
direction to switch off the appliance.
Using the micro trimmer to form the eyebrows or remove
individual facial hairs
You can use the micro trimmer
to form the eyebrows or remove individual facial hairs.
1) Start by removing any other attachment from the hand element
-
, if required.
Fit the micro trimmer
on the hand element
-
. The slight curvature of the micro
trimmer
must be facing towards the side of the hand element
-
on which the
on/off button
3
is located (see chapter "Fitting/removing the attachments").
2) Push the on/off switch
3
in the direction of the attachment.
3) Move the micro trimmer
in a careful and controlled manner. Always move the micro
trimmer
against the direction of hair growth. Ensure that the micro trimmer
is
always fully in contact with your skin.
4) When you are finished with the treatment, push the on/off switch
3
in the opposite
direction to switch off the appliance.
Содержание 273442
Страница 3: ...B A C ...
