6
SEMD 12 A1
GB
Making ice cream
CAUTION! MATERIAL DAMAGE!
►
Start the appliance fi rst and then add ingre-
dients. Otherwise the ice mixture will freeze
onto the sides of the beaker
8
and block the
ice scrapers
7
. This will cause the motor to
overheat!
CAUTION! MATERIAL DAMAGE!
►
Do not stop the appliance during processing!
Otherwise the ice mixture will freeze onto
the sides of the beaker
8
and block the ice
scrapers
7
when the machine is restarted.
This will cause the motor to overheat!
1) Remove the beakers
8
from the freezer and
put the appliance together as described in the
section “Assembly”.
2) Switch the appliance on by moving the On/
Off switch
1
to the position I. The two ice
scrapers
7
start turning.
3) Now fi ll the prepared ice mixture into the beak-
ers
8
through the fi lling openings
4
. Ideally,
use a bowl with a spout. Never add more than
300 ml per beaker
8
. During processing the
mixture increases in volume!
NOTE
►
You can also fi ll only one beaker
8
with
ingredients. However, always use the appli-
ance with both beakers.
NOTE
►
The ice scrapers
7
may occasionally change
their direction of rotation. This happens when
the mixture becomes too stiff . This is normal
and not an appliance defect.
4) Allow the appliance to continue running until
you are satisfi ed with the consistency of the
mixture. After a maximum of 20 to 30 minutes,
the ice cream is ready.
5) Switch the appliance off at the On/Off switch
1
and pull the mains power plug out of the socket.
6) Turn the rotary switch
9
to to remove the
lid
5
with the motor unit
2
.
7) Pull the ice scrapers
7
out of the ice cream.
If the ice cream sticks to them, scrape it off with
a plastic spoon or similar.
8) Lift the beakers
8
out of the appliance and
remove the ice cream. Use only plastic or
wooden implements to do this.
CAUTION! MATERIAL DAMAGE!
►
Do not use metal utensils to remove the ice
cream from the beakers
8
.
NOTE
►
If you would like to replace the lid
5
on
the beakers, you must fi rst detach the motor
unit
2
from the lid
5
. Then proceed as de-
scribed in the section "Assembly". Otherwise,
it is possible that the drive shafts
3
do not
slide correctly into the drive shaft socket
6
.
IB_111458_SEMD12A1_LB4.indb 6
05.03.15 10:25
Содержание 111458
Страница 3: ......