SILVER Audio Processor 4Bmini User’s manual
Page 31/38
Audemat-Aztec SA – Audemat-Aztec INC
web: www.audemat-aztec.com - e-mail: [email protected]
Scheduling
There are three menu locations for controlling scheduling. The first location is shown in the screen shot above and it
contains the ON/OFF and time setting control. The two menu locations below it access two banks of four dayparts
which make up the 8 dayparts contained in the SILVER Audio Processor 4Bmini..
On the daypart windows you have four dayparts. Each has three parameters. The left hand box contains the name of
the preset that you want this daypart to switch to. This box also has the ability to turn the daypart OFF by clicking
down on the arrows until you reach the off option. If off is currently selected you can click up to rotate through the
user and factory presets. The middle box contains the time and day that the daypart will start at. To select day, hour
or minute click on the appropriate part of the box before using the up and down arrows. The day part of the time also
has an ALL option. This means that the daypart will occur on every day. The right most box contains the length of the
daypart in hours and minutes. Like the start time of the daypart you will need to click into the appropriate part of the
box before clicking the up/down arrows.
The dayparts can be layered so that one can override another. Let's say the default preset was U1:MAIN PRESET
and this was on the air all of the time. We want to change the preset from 7AM to 10AM every day of the week to
F2:CHR and then from 10AM to 12PM we want U4:NEW PRESET and then back to F2:CHR until 5PM.
Rather than setup the dayparts as
DPO: F2:CHR - ALL 07:00 - 03:00
(factory preset 2 to run from 7AM everyday for 3 hours)
DP1: U4:NEW PRESET - ALL 10:00 - 02:00
(user preset 4 to run from 10am everyday for 2 hours)
DP2: F2:CHR - ALL 12:00 - 05:00
(factory preset 2 to run from 12pm everyday for 5 hours)
Scheduling
